Methoxy-Substituted Tyramine Derivatives Synthesis,Computational Studies and Tyrosinase Inhibitory Kinetics

Targeting tyrosinase for melanogenesis disorders is an established strategy. Hydroxyl-substituted benzoic and cinnamic acid scaffolds were incorporated into new chemotypes that displayed in vitro inhibitory effects against mushroom and human tyrosinase for the purpose of identifying anti-melanogenic ingredients. The most active compound 2-((4-methoxyphenethyl)amino)-2-oxoethyl (E)-3-(2,4-dihydroxyphenyl) acrylate (Ph9), inhibited mushroom tyrosinase with an IC₅₀ of 0.059 nM, while 2-((4-methoxyphenethyl)amino)-2-oxoethyl cinnamate (Ph6) had an IC₅₀ of 2.1 nM compared to the positive control, kojic acid IC₅₀ 16700 nM. Results of human tyrosinase inhibitory activity in A375 human melanoma cells showed that compound (Ph9) and Ph6 exhibited 94.6% and 92.2% inhibitory activity respectively while the positive control kojic acid showed 72.9% inhibition. Enzyme kinetics reflected a mixed type of inhibition for inhibitor Ph9 (K_i 0.093 nM) and non-competitive inhibition for Ph6 (K_i 2.3 nM) revealed from Lineweaver–Burk plots. In silico docking studies with mushroom tyrosinase (PDB ID:2Y9X) predicted possible binding modes in the catalytic site for these active compounds. Ph9 displayed no PAINS (pan-assay interference compounds) alerts. Our results showed that compound Ph9 is a potential candidate for further development of tyrosinase inhibitors.     

Experimental Heat Transfer Coefficients of Waste Heat Recovery Unit in Detergent Manufacturing Process

The waste heat recovery unit is one of the most important units in the chemical process. It recovers waste heat from the exhaust gas of the process resulting in the reduction of heat loss. In the detergent manufacturing process, the particulate air leaving the spray dryer is the exhaust gas containing the large amount of heat. Therefore, a waste heat recovery unit can significantly reduce heat loss. In this work, heat transfer coefficients of a waste heat recovery unit in the detergent manufacturing process were studied. Waste heat from the particulate air is recovered in the shell and coiled tube heat exchanger. The particulate air flows in the shell side, and water flows in the tube side. Four coiled tubes with different coil pitches were investigated. The results show that the tube-side heat transfer coefficient increases as the coil pitch decreases. Loading ratio also has an important effect on heat transfer coefficients. The increase of loading ratio leads to a lower value of the overall heat transfer coefficient. From 100 experiments, empirical correlations for the prediction of tube-side and shell-side heat transfer coefficients were proposed. The results indicate that the predicted heat transfer coefficients agree well with the experimental values.     

New bisbibenzyl and phenanthrene derivatives from Dendrobium scabrilingue and their α-glucosidase inhibitory activity

Abstract

Phytochemical investigation of the whole plant of Dendrobium scabrilingue resulted in the isolation of two new compounds namely dendroscabrols A (1) and B (2), along with eight known compounds (3–10). The structures of these compounds were determined by NMR and HR-ESI-MS experiments. All of the isolates were evaluated for their α-glucosidase inhibitory effect. Dendroscabrol B (2) and RF-3192C (10) showed the most potent α-glucosidase inhibitory activity. Dendroscabrol A (1), gigantol (5), coelonin (7) and lusianthridin (9) also exhibited strong activity as compared with the positive control acarbose.     

Synthesis, characterization and biological evaluation of succinate prodrugs of curcuminoids for colon cancer treatment

A novel series of succinyl derivatives of three curcuminoids were synthesized as potential prodrugs. Symmetrical (curcumin and bisdesmethoxycurcumin) and unsymmetrical (desmethoxycurcumin) curcuminoids were prepared through aldol condensation of 2,4-pentanedione with different benzaldehydes. Esterification of these compounds with a methyl or ethyl ester of succinyl chloride gave the corresponding succinate prodrugs in excellent yields. Anticolon cancer activity of the compounds was evaluated using Caco-2 cells. The succinate prodrugs had IC?? values in the 1.8-9.6 μM range, compared to IC?? values of 3.3-4.9 μM for the parent compounds. Curcumin diethyl disuccinate exhibited the highest potency and was chosen for stability studies. Hydrolysis of this compound in phosphate buffer at pH 7.4 and in human plasma followed pseudo first-order kinetics. In phosphate buffer, the k(obs) and t(?) for hydrolysis indicated that the compound was much more stable than curcumin. In human plasma, this compound was able to release curcumin, therefore our results suggest that succinate prodrugs of curcuminoids are stable in phosphate buffer, release the parent curcumin derivatives readily in human plasma, and show anti-colon cancer activity.     

Simultaneous estimation of thin film thickness and optical properties using two-stage optimization

In this work, we proposed the new method for estimation of the thickness and the optical properties of the thin metal oxide film deposited on a transparent substrate. The developed method uses only transmittance spectra measured. Our method is based on the two stage optimization where the thickness is determined in the outer stage and the optical properties are determined in the inner stage. The differential evolutionary algorithm is used in solving the formulated problem. The proposed method was illustrated in the case study of Titanium dioxide film deposited on a glass substrate. The results indicate that the thickness and the optical properties estimated agree well with the experiment. Moreover, we investigated robustness of the proposed method in the case of transmittance spectra containing noises. The data were modelled by adding random noises ranging between 0 and 30% to the transmittance spectra measured. It is seen that the proposed method has better robustness and performance than the existing method based on pointwise unconstrained minimization approach. In solving the estimation problem, the performance of the proposed method was also compared with the well-known Levenberg?CMarquardt method and single stage differential evolutionary method. The results indicate that the proposed method has better performance than Levenberg?CMarquardt method and single stage differential evolutionary method. Moreover, the proposed method is more robust to random noise than Levenberg?CMarquardt method and single stage differential evolutionary method.     

Electrophoretic mobility of duplex DNA cross‐linked by mechlorethamine at a cytosine–cytosine mismatch pair

The common nitrogen mustard, mechlorethamine, can form a covalent cross‐link between the two bases of a cytosine–cytosine mismatch pair within a DNA duplex. The cross‐linked species can be readily separated from DNA monoadducts and unreacted strands using denaturing polyacrylamide gel electrophoresis. Here, using DNA 19 mer duplexes that are mechlorethamine cross‐linked at a C₄–C₃₅, C₇–C₃₂, C₁₀–C₂₉, or C₁₃–C₂₆ mismatch pair, we show that the denaturing polyacrylamide gel electrophoresis mobility of the cross‐linked species is particularly sensitive to the proximity of the C–C cross‐link to the duplex end. Species that are cross‐linked at a C₄–C₃₅ mismatch have greater mobilities than those cross‐linked at C₇–C₃₂ or C₁₃–C₂₆, and the species with a central C₁₀–C₂₉ cross‐link have the lowest mobility. The mobility is also dependent on the proximity of the cross‐link to a 5′‐³²P‐phosphate or a 5′‐fluorescein label. We interpret these results in terms of the conformational properties of the cross‐linked species in the denaturing gel. The results are consistent with the retention of partial duplex character at the end proximal to the cross‐link, with an influence on the mobility of the GC/AT ratio proximal to the cross‐link and at the duplex end, and a small but discernible effect of the label.     

Effect of carboxymethyl cellulose concentration on physical properties of biodegradable cassava starch-based films

Background  

Cassava starch, the economically important agricultural commodity in Thailand, can readily be cast into films. However, the cassava starch film is brittle and weak, leading to inadequate mechanical properties. The properties of starch film can be improved by adding plasticizers and blending with the other biopolymers.     

A Stability-Indicating Ultra Performance Liquid Chromato-Graphic (UPLC) Method for the Determination of a Mycophenolic Acid-Curcumin Conjugate and Its Applications to Chemical Kinetic Studies

A simple, precise, and accurate reversed-phase ultra-performance liquid chromatographic (UPLC) method was developed and validated for the determination of a mycophenolic acid-curcumin (MPA-CUR) conjugate in buffer solutions. Chromatographic separation was performed on a C18 column (2.1 × 50 mm id, 1.7 µm) with a gradient elution system of water and acetonitrile, each containing 0.1% formic acid, at a flow rate of 0.6 mL/min. The column temperature was controlled at 33 °C. The compounds were detected simultaneously at the maximum wavelengths of mycophenolic acid (MPA), 254 nm, and curcumin (CUR), or MPA-CUR, at 420 nm. The developed method was validated according to the ICH Q2(R1) guidelines. The linear calibration curves of the assay ranged from 0.10 to 25 μg/mL (r² ≥ 0.995, 1/x² weighting factor), with a limit of detection and a limit of quantitation of 0.04 and 0.10 μg/mL, respectively. The accuracy and precision of the developed method were 98.4–101.6%, with %CV < 2.53%. The main impurities from the specificity test were found to be MPA and CUR. Other validation parameters, including robustness and solution stability, were acceptable under the validation criteria. Forced degradation studies were conducted under hydrolytic (acidic and alkaline), oxidative, thermal, and photolytic stress conditions. MPA-CUR was well separated from MPA, CUR, and other unknown degradation products. The validated method was successfully applied in chemical kinetic studies of MPA-CUR in different buffer solutions.     

Extraction of Tropical Fruit Peels and Development of HPMC Film Containing the Extracts as an Active Antibacterial Packaging Material

In recent years, instead of the use of chemical substances, alternative substances, especially plant extracts, have been characterized for an active packaging of antibacterial elements. In this study, the peels of mangosteen (Garcinia mangostana), rambutan (Nephelium lappaceum), and mango (Mangifera indica) were extracted to obtain bioactive compound by microwave-assisted extraction (MAE) and maceration with water, ethanol 95% and water–ethanol (40:60%). All extracts contained phenolics and flavonoids. However, mangosteen peel extracted by MAE and maceration with water/ethanol (MT-MAE-W/E and MT-Ma-W/E, respectively) contained higher phenolic and flavonoid contents, and exhibited greater antibacterial activity against Staphylococcus aureus and Escherichia coli. Thus, both extracts were analyzed by liquid chromatograph-mass spectrometer (LC-MS) analysis, α-mangostin conferring antibacterial property was found in both extracts. The MT-MAE-W/E and MT-Ma-W/E films exhibited 30.22 ± 2.14 and 30.60 ± 2.83 mm of growth inhibition zones against S. aureus and 26.50 ± 1.60 and 26.93 ± 3.92 mm of growth inhibition zones against E. coli. These clear zones were wider than its crude extract approximately 3 times, possibly because the film formulation enhanced antibacterial activity with sustained release of active compound. Thus, the mangosteen extracts have potential to be used as an antibacterial compound in active packaging.     

High Substitution Synthesis of Carboxymethyl Chitosan for Properties Improvement of Carboxymethyl Chitosan Films Depending on Particle Sizes

This study investigated the effect of chitosan particle sizes on the properties of carboxymethyl chitosan (CMCh) powders and films. Chitosan powders with different particle sizes (75, 125, 250, 450 and 850 µm) were used to synthesize the CMCh powders. The yield, degree of substitution (DS), and water solubility of the CMCh powders were then determined. The CMCh films prepared with CMCh based on chitosan with different particle sizes were fabricated by a solution casting technique. The water solubility, mechanical properties, and water vapor transmission rate (WVTR) of the CMCh films were measured. As the chitosan particle size decreased, the yield, DS, and water solubility of the synthesized CMCh powders increased. The increase in water solubility was due to an increase in the polarity of the CMCh powder, from a higher conversion of chitosan into CMCh. In addition, the higher conversion of chitosan was also related to a higher surface area in the substitution reaction provided by chitosan powder with a smaller particle size. As the particle size of chitosan decreased, the tensile strength, elongation at break, and WVTR of the CMCh films increased. This study demonstrated that a greater improvement in water solubility of the CMCh powders and films can be achieved by using chitosan powder with a smaller size.